Set-Misc
The Set-Misc dynamic module extends the NGINX core Rewrite by implementing numerous additional set_*
directives.
-
Check the Technical Specifications page to verify that the module is supported by your operating system.
-
Make sure that your operating system is configured to retrieve binary packages from the official NGINX Plus repository. See installation instructions for your operating system on the Installing NGINX Plus page.
-
Prior to installing the module, verify that the NDK module is already installed.
Install the Set-Misc module package nginx-plus-module-set-misc
from the official NGINX Plus repository.
For Amazon Linux 2, CentOS, Oracle Linux, and RHEL:
sudo yum update && \
sudo yum install nginx-plus-module-set-misc
For Amazon Linux 2023, AlmaLinux, Rocky Linux:
sudo dnf update && \
sudo dnf install nginx-plus-module-set-misc
For Debian and Ubuntu:
sudo apt update && \
sudo apt install nginx-plus-module-set-misc
For SLES:
sudo zypper refresh && \
sudo zypper install nginx-plus-module-set-misc
For Alpine:
apk add nginx-plus-module-set-misc
For FreeBSD:
sudo pkg update && \
sudo pkg install nginx-plus-module-set-misc
After installation you will need to enable and configure the module in F5 NGINX Plus configuration file nginx.conf
.
-
Enable dynamic loading of NDK and Set-Misc modules with the
load_module
directives specified in the top-level (“main
”) context:load_module modules/ndk_http_module.so; load_module modules/ngx_http_set_misc_module.so; http { # ... }
Note: The directives must be in this order. -
Perform additional configuration as required by the module.
-
Test the NGINX Plus configuration. In a terminal, type-in the command:
nginx -t
Expected output of the command:
nginx: the configuration file /etc/nginx/nginx.conf syntax is ok nginx: configuration file /etc/nginx/nginx.conf is successful
-
Reload the NGINX Plus configuration to enable the module:
nginx -s reload